Teledyne-lecroy STX M6-1 SAS_SATA Protocol Analyzer User Manual Bedienungsanleitung PDF herunterladen (Seite 384)

100

101

LeCroy Corporation Overview of Generation and Global Settings Files

382

 Sierra M6‐4 SAS/SATA Protocol Analyzer User Manual

When editing global settings, keep in mind the following rule: The last line encountered

before the generation block takes precedence. Thus, if the following two lines about the

device emulation were added just above the generation block, the second would take

effect:

set GenerationMode = GEN_MODE_SATA_HOST

set GenerationMode = GEN_MODE_SAS_INITIATOR

The Global Setting “AutoAlign”

AutoAlign is a global setting that may be on or off depending on the type of device you

are emulating. There is an AutoAlign setting for SAS and one for SATA, for example, “set

AutoAlignSAS = ON” and “set AutoAlignSATA=OFF.”

 SAS: Sends AutoAligns every 2048 DWORDs.

 SATA: Sends AutoAligns every 256 DWORDs.

If you plan to set and reset AutoAlign in the middle of traffic generation, you need to

know what the defaults are for AutoAlign. The defaults are as follows:

For SATA host/device emulation,:

 AutoAlignSATA is assumed to be ON.

 AutoAlignSAS is assumed to be OFF.

For SAS emulation, the assumptions are opposite:

 AutoAlignSATA is assumed to be OFF.

 AutoAlignSAS is assumed to be ON.

For STP:

 AutoAlignSAS and AutoAlignSATA are assumed to be ON.

1 2 ... 379 380 381 382 383 384 385 386 387 388 389 ... 467 468

Kommentare zu diesen Handbüchern

Keine Kommentare

Teledyne-lecroy STX M6-1 SAS_SATA Protocol Analyzer User Manual Bedienungsanleitung Seite 384

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ausrüstung Teledyne-lecroy STX M6-1 SAS_SATA Protocol Analyzer User Manual